NCASE M1 Vertical SFF Mini ITX Case GPU Mounting Bracket 3.0 atlas-ii feet semi-suspended design with an 'egg'

semi-suspended design with an 'egg' shaped subchassis

After removing bottom cover on your Thorens turntable

These perform better than any inexpensive solution that I’ve found for my Pioneer PL-series turntable and can stop your needle cartridge from skipping for an improved hi-fi listening experience

Mnpctech makes these replacement feet for Garrard Turntables

I took a deep breath and began installation by unscrewing each foot one by one until all four had been removed from their respective mounting points on my turntable's baseplate

NCASE M1 Vertical SFF Mini ITX Case GPU Mounting Bracket 3.0 atlas-ii feet semi-suspended design with an 'egg'READ BEFORE ORDERING. *NCASE M1 Vertical GPU Mounting Bracket requires cutting hole in rear of NCASE chassis for the monitor cable(s) *This product wasn't designed for all NCASE system configurations. Bracket adds 1 2" length to your video card. *Requires low profile CPU cooler (75mm or shorter) like the CRYORIG C7 used for the M1 build pictured on this page. *A PCI E riser cable is required to connect your video card to motherboard and sold