CrimpCenter Training (1 day, Factory or Field session) Software_S.DRIVE setting up the crimping presses

setting up the crimping presses and basic EASY programming and operation to produce your first wire

create a basic cable program by creating raw material files and then combine them into a job file

The course is not intended to provide students with extensive knowledge in these areas but to familiarize them with critical processes by introducing them to the basic concepts in wire processing

but to give you an introduction to the basic programming steps

the general operation of a pull tester

CrimpCenter Training (1 day, Factory or Field session) Software_S.DRIVE setting up the crimping pressesWant to get some additional training on your Schleuniger CrimpCenter machine? Have new operators you need trained? We're available. This is a 1 day (8 hour) session with one of our experts. You'll learn about basic machine configurations, loading wires, terminals and seals, setting up the crimping presses and get you started with EASY programming and operation to produce your first wire. We'll instruct you on optimizing your set ups, adjusting and