George's Garage, cam & pinion gear gauge pins .105" - 54-89 B.T.(NU) 519523 Note: Must re-use original adjusting

Note: Must re-use original adjusting screw & locknut kit (MCS 556634 / Repl

Seating position moved 1

WITH THROTTLE BOSS

These are meant to slide on like any other standard rubber grip… A throttle tube is required for these grips to work on your MC… Grip does not include a built in throttle tube… Each set comes with two grips

10-Gauge Front Master Cylinder Cover

George's Garage, cam & pinion gear gauge pins .105" - 54-89 B.T.(NU) 519523 Note: Must re-use original adjusting. 105 inch diameter. Used to check pinion and cam gears for pitch diameters. A loose fit results in a clicking noise but a tight fit in a whining noise that may result in gear tooth & bearing damage. For sizing charts, see the OEM H D service manual.